NEWS

»How do I mix the two-part Gap Fillers? 2016-07-26

A: Disposable plastic static mixing nozzles are used to mix parts Aand B together at the desired ratio. Static mixers can be attachedto the ends of cartridges o...

»Is Gap Filler reworkable? 2016-07-21

A: In many cases, Thermal Gap Filler can be reworked. The ease of reworkis highly dependent on the topography of the application as wellas the coverage area....

»Does Gap Filler have adhesive characteristics? 2016-07-20

A: Gap Fillers are not designed as structural adhesives,when cured, they have a low level of natural tack, which willallow the material to adhere mildly to adja...

»Does temperature above 25°C affect the characteristics? 2016-07-18

A: Short periods of time above the recommended storage tempera-ture, such as during shipping, have not been shown to affect thematerial characteristics....

»How to store the two-part gap filler? 2016-07-15

A: Unless otherwise indicated on product data sheets, two-part GapFillers should be stored in the original sealed container in a climatecontrolled environment a...

»How is viscosity measured 2016-07-13

A: Due to the thixotropic characteristics of most Gap Fillers, specialconsideration should be given to the test method(s) used todetermine viscosity of these ma...

»In which applications should I avoid using PCM? 2016-07-12

A:  Avoid using PCM in  applications in which the device willnot reach operation at or above phase change temperature. Alsoavoid applications in which...

»Why is PCM gap filler phase change temperature 60°? 2016-07-11

A: The 60 ° phase change temperature was selected for two reasons.First, it was a low enough temperature for the phase change tooccur in applications. Seco...